Powerus PW10000

Beschreibung

Powerus presents the Powerus PW10000 Full-range 1-channel amplifiers, the latest in amplifier technology from the Brazilian market, all of which are 0.5 Ohm stable and offer a wide range of impedance options! 
With the different impedance options you have  the ability to provide maximum performance for any subwoofer setup. 
All Powerus amplifiers also have advanced protection circuitry that protects against installation errors and dirty signals, such as the exclusive limiter function that protects against clipping on the subwoofer.

Performance of the 0.5 Ohm version with 14.4V:

• At 0.5 Ohm connection: 11900 Watt RMS
• At 1 Ohm connection 8760 Watt RMS
• At 2 Ohm connection 5290 Watt RMS
• With 4 Ohm connection  3584  Watt RMS

Performance of the 1 Ohm version with 14.4V

• At 1 Ohm connection: 11900 Watt RMS
• At 2 Ohm connection 8760 Watt RMS
• With 4 Ohm connection  5290  Watt RMS

Performance of the 2 Ohm version with 14.4V

• At 2 Ohm connection: 11900 Watt RMS
• At 4 Ohm connection 8760 Watt RMS

Technical data

• power connection terminal: 50mm²
• Frequency response 5Hz ~ 20KHz (- 1dB)
• Supply voltage 7Vdc ~ 16V dc
  
• consumption in idle mode  2.8A
  
• Power consumption with music: 570A
• Max. consumption with sine signal at 40Hz: 1145A
  
• Efficiency: 75%
  
• Input impedance: 22 kOhm
  
• Input sensitivity: 0.25V ~ 6V
  
• Total Harmonic Distortion THD: 0.1%
  
• Signal-to-noise ratio SNR: >90dB
  
• Damping factor 40Hz (12.6V 2 Ω): >1000
• Low-pass crossover:  80Hz ~ 20KHz 
  
• High pass crossover: 5Hz ~ 200Hz
  
• Bass Boost Gain: 0dB ~ 18dB
  
• Variable boost frequency: 28Hz ~ 400Hz
• Dimensions (HxWxD): 70x280x450 mm 
  
• Weight: 7.8kg

Installation instructions

• To install the power supply, use cables with a cross-section of 50mm² or more, as well as 50mm² to 3x50mm² terminal adapters, which you can find separately in our shop. The positive cable must come directly from the battery, with a fuse or circuit breaker 30cm away from the battery. The negative cable must have the same cross-section as the positive cable.