DD Audio M5000

Meet the M5000, DD Audio's most advanced 1-channel amplifier. This innovative device takes the M-Series to a new level of performance and efficiency without increasing its compact size. The ultra-high current output is optimized through intelligent configuration, while the design is based on features from the award-winning Z12000 and extended operating voltage. As a result, the M5000 can take full advantage of today's lithium batteries and represents the best power-to-space ratio yet. Additional features such as improved end plates for increased airflow, optimized over-high current power supply and app-controlled LED vanity plates increase the performance and versatility of this amplifier even further.

• DD AUDIO redefines the venerable M-Series with new versions that significantly improve performance and efficiency without increasing the size of the unit. The M5000 incorporates the best ultra-high current devices and optimizes their use through intelligent configuration to maintain the modest footprint of its predecessor.
• The new M-Series builds on the design features of the award-winning Z12000 and extends the operating voltage through improvements to the power supply, output section and high-efficiency heat sink, reaching the maximum operating voltage of 16V and taking full advantage of today's lithium batteries. These improvements enable the best performance to space ratio yet!
• To further increase performance, the M-Series features new end plates that raise the amplifiers off the mounting surface, allowing the internal fan to pull more air through the circuit board, even on carpeted or padded surfaces.
• These high-current half-bridge amplifiers are more compact, lighter and more powerful than all previous M-series.
• Be sure to check out the app-controlled LED vanity plates available for the M2500, M5000 and M8000!
• Optimized over-high current power supply
• Stackable half-bridge design
• ZVL link module input
• 24dB/Oct bandpass filter
• Custom Vanity Plate Ready
• Remote control / LCD voltage display and clipping indicator
• 5000 watts RMS continuous power

• Operating voltage: 9-16
• Test voltage: 14.4
• Input channel(s): 1
• Continuous power @4ohm: 1900
• Continuous power @2Ohm: 3000
• Continuous power @1Ohm: 5000
• Dynamic wattage: 7000
• Maximum current consumption (amperes): 700
• RCA input voltage sensitivity: 8 - 0.2
• RCA input S/N: > 97
• Damping factor: > 400
• Frequency response (Hz): 20 - 500
• Subsonic filter: 20 - 250Hz
• Low-pass filter: 50 - 500Hz
• ZVL input: Yes
• Pass Thru Exit: No
• Remote control: Remote control included
• Power cable thickness: 2 x 0
• Speaker wire gauge: 10
• Dimensions (inches): 13.4 x 9 x 2.6
• Dimensions (MM): 340 x 230 x 66