Hertz Mille Legend MLCX 2 TW.3

The Mille Legend MLCX 2 TW.3 from Hertz sets new standards in the world of crossovers. It allows you to set up a two-amplifier system and therefore offers a significant increase in performance. The special mid and hi-cut controls allow you to vary the crossover point and finely adjust the frequency response of the system. This allows you to optimally complement the characteristic sound of your vehicle or achieve your favorite sound. The performance of the MLCX 2 TW.3 is impressive, with a power handling of up to 300 peak W and a depth of 41 mm. Special features of this model are the adjustment options, such as the tweeter, hi-boost and mid-range contour, which you can use as needed. If you consider all of these functions together, the Mille Legend MLCX 2 TW.3 is a crossover that leaves nothing to be desired.

• component crossover
• load capacity - Peak W 300
• Resilience - Peak Note 150
• Depth mm 41 
• Attitude
• tweeter +2 / 0 / -2 dB
• Hi-Boost ON / OFF
• Hi-Contour ON / OFF
• Center contour ON / OFF
• Bi-Amp ON / OFF
• Weight of one component - crossover kg 0.57 (
• crossover
• Woofer Lo-Pass 6 dB Oct.
• Tweeter high pass 12 dB Oct.
• cutoff frequency 2.5 kHz (Mid/Hi-Cont. = ON)
• 3.5 kHz (Mid/Hi-Cont. = OFF)

• G 195 mm 
• H 119 mm 
• I 41 mm 

•   Bi-amplification available, selectable via a corresponding high current switch with high current carrying capacity.
•   Mid-contour control with two positions for a linear frequency response in the mid-bass range, depending on the position of the woofer in the car and the listener's favorite sound.
•   Hi-Contour two-position control to select the tweeter's high frequency crossover point according to the tweeter's position/angle to the listener.
•   Mid-Contour in combination with Hi-Contour offers the possibility of building a two-way system with the MLCX 2 TW.3 consisting of ML 1650.3 or ML 1800.3 woofer and ML 280.3 tweeter.
•   Three-position switch for adjusting the tweeter level in 2 dB steps for fine-tuning the
• Radiation of the transducer.
•   Hi-Boost control, selectable via the corresponding switch, for better linearity of the tweeter above 10 kHz when it is not on axis with the listener.
•   Extremely high quality 160V bimetallic polyester film capacitors with extremely low DF for maximum sound transparency and clean mid/high frequencies.
•   Air-wound coils made of pure copper wire with a diameter of up to 1 mm for a high saturation limit of the magnetic flux and low losses in the low frequency range where high transient currents are required.
•  High power rated wirewound resistors to ensure performance stability even at high operating temperatures. The wirewound construction provides low parasitic series inductance and thus lower losses at high frequencies, especially for resistors in series with the tweeter.