SB Acoustics Satori WO24P / Paper
10" (25cm) woofer
/Piece
Inkl. MwSt. Exkl. MwSt. inkl. Versandkosten exkl. Versandkosten
Du sparst 5% auf diesen Artikel, indem du beim Bestellvorgang die Zahlungsart Vorkasse (Banküberweisung) wählst Der Rabatt wird automatisch abgezogen!
Günstiger gesehen?
„Wir halten mit - garantiert!" Nutze die Tiefpreisgarantie! Wenn du einen Artikel auf einer Internetseite innerhalb der EU günstiger findest, ziehen wir mit dem Preis der Konkurrenz gleich und legen einen Artikel aus unserem Zubehörsortiment bei.
Beschreibung
The SB Acoustics SATORI WO24P 10" (25cm) woofer with patented Paper/Payprus membrane is available in a 4 Ohm and 8 Ohm version. The ultra-light membrane is supported by a powerful ferrite magnet The resonance frequency of around 30 Hz is far outside the usable range, which means that the driver is extremely linear in the usable range and can be used optimally in 2-way operation or as a woofer. The generously ventilated centering spider optimizes the rear compression behavior to a maximum and provides additional cooling.
Features:
- Hard paper cone for improved piston running (own production)
- Large optimized motor system with undercut pole piece and double short-circuit rings
- Ventilated, aerodynamic cast aluminum chassis for optimal strength and low compression
- Soft rubber surround with low damping for optimal transient response
- Linear symmetrical suspension for improved dynamic performance
- Non-conductive glass fiber voice coil former for minimal damping
- Durable silver wires offset by 180° for improved stability
- Ventilated pole piece for reduced compression
- Low ratio of piston to chassis diameter
- Overhangs in the seals and screw holes for a lower coupling to the loudspeaker housing
Data 4 Ohm variant
- nominal impedance 4 Ω
- frequency range 40Hz - 2.5kHz
- DC resistance, Re 3.3 Ω
- Inductance of the voice coil, Le 0.29 mH
- Effective membrane area, Sd 255 cm2
- Diameter of the voice coil 49.5 mm
- Height of the voice coil 23 mm
- height of the air gap 6 mm
- Linear coil stroke (pp) 17 mm
- Magnetic flux density 1.1 T
- Weight of the magnet 1.36 kg
- net weight 3.7 kg
- Free air resonance, Fs 28 Hz
- Sensitivity (2.83V/1m) 91 dB
- Mechanical Q-factor, Qms 6.7
- Electrical Q-factor, Qes 0.42
- overall Q-factor, Qts 0.40
- Moving mass including air, Mms 42 g
- force factor, Bl 7.6 Tm
- Equivalent volume, Vas 71 liters
- Compliance, Cms 0.77 mm/N
- Mechanical loss, Rms 1.1 kg/s
- Nominal load capacity* 90 W
- * IEC 268-5, T/S parameters measured on retracted drive units.
Data 8 Ohm variant
- nominal impedance 8 Ω
- frequency range 40Hz - 2.5kHz
- DC resistance, Re 5.8 Ω
- Inductance of the voice coil, Le 0.56 mH
- Effective membrane area, Sd 255 cm2
- Diameter of the voice coil 49.5 mm
- Height of the voice coil 23 mm
- height of the air gap 6 mm
- Linear coil stroke (pp) 17 mm
- Magnetic flux density 1.1 T
- Weight of the magnet 1.36 kg
- net weight 3.7 kg
- Free air resonance, Fs 24.5 Hz
- Sensitivity (2.83V/1m) 88 dB
- Mechanical Q-factor, Qms 5.7
- Electrical Q factor, Qes 0.41
- overall Q-factor, Qts 0.38
- Moving mass including air, Mms 44.5 g
- force factor, Bl 9.9 Tm
- Equivalent volume, Vas 87.5 liters
- Compliance, Cms 0.95 mm/N
- Mechanical loss, Rms 1.2 kg/s
- Nominal load capacity* 90 W
- * IEC 268-5, T/S parameters measured on retracted drive units.
Dimensions