SB Acoustics Satori MR13PNW / Paper

The SB Acoustics SATORI MR13PNW 5" (13cm) midrange driver with paper/papyrus cone is available in a 4 Ohm and 8 Ohm version. The ultra-light cone is driven by a powerful neodymium motor. The resonance frequency around 40 Hz is far outside the usable range, which means that the driver plays extremely linearly in the usable range.

• Ventilated, aerodynamic cast aluminum chassis for optimum strength and low compression
  
• Proprietary cone material with EGYPTIAN PAPYRUS fibers from our own production
  
• Soft rubber surround with low damping for optimum transient response
  
• Advanced BIMAX spider for improved linearity
  
• Powerful, optimized neodymium motor system with low distortion
  
• Non-conductive glass fiber voice coil former for minimal attenuation
  
• Extended copper sleeve on the pole piece for low inductance and reduced distortion
  
• CCAW voice coil for reduced moving mass
  
• Durable silver wires with 180° spacing for improved stability
  
• Ventilated pole piece and coil carrier for reduced compression
  
• Low ratio of piston to chassis diameter
  
• Protrusions in the seal and in the screw holes for reduced coupling to the speaker housing

• Nominal impedance 4 Ω
  
• Frequency range: 60Hz - 4kHz
• Direct current resistance, Re 3.3 Ω
  
• Inductance of the voice coil, Le 0.11 mH
  
• Effective diaphragm area, Sd 70 cm2
  
• Diameter of the voice coil 30.5 mm
  
• Height of the voice coil 11 mm
  
• Height of the air gap 5 mm
  
• Linear coil stroke (p-p) 6 mm
  
• Magnetic flux density 1.08 T
  
• Weight of the magnet 0.1 kg
  
• Net weight 0.78 kg
  
• Free air resonance, Fs 41 Hz
  
• Sensitivity (2.83 V / 1 m) 91 dB
  
• Mechanical Q-factor, Qms 2.8
  
• Electrical Q-factor, Qes 0.25
  
• Total Q-factor, Qts 0.23
  
• Moving mass incl. air, Mms 5.4 g
  
• Force factor, Bl 4.3 Tm
  
• Equivalent volume, VAS 19.4 liters
  
• Compliance, Cms 2.79 mm/N
  
• Mechanical loss, Rms 0.5 kg/s
  
• Rated load capacity* 30 W
  
• * IEC 268-5, high-pass Butterworth, 200 Hz, 12 dB/oct.

• Nominal impedance 8 Ω
  
• Frequency range: 60Hz - 4kHz
• Direct current resistance, Re 6.8 Ω
  
• Inductance of the voice coil, Le 0.11 mH
  
• Effective diaphragm area, Sd 70 cm2
  
• Voice coil diameter 30.5 mm
  
• Height of the voice coil 11 mm
  
• Height of the air gap 5 mm
  
• Linear coil stroke (p-p) 6 mm
  
• Magnetic flux density 1.08 T
  
• Weight of the magnet 0.1 kg
  
• Net weight 0.78 kg
  
• Free air resonance, Fs 47 Hz
  
• Sensitivity (2.83 V / 1 m) 88 dB
  
• Mechanical Q-factor, Qms 4.58
  
• Electrical Q-factor, Qes 0.32
  
• Total Q-factor, Qts 0.3
  
• Moving mass incl. air, Mms 6.2 g
  
• Force factor, Bl 6.2 Tm
  
• Equivalent volume, VAS 12.9 liters
  
• Compliance, Cms 1.85 mm/N
  
• Mechanical loss, Rms 0.4 kg/s
  
• Rated load capacity* 30 W
  
• * IEC 268-5, high-pass Butterworth, 200 Hz, 12 dB/oct.