Our complete sets consist of components that are perfectly matched to each other, both in terms of sound and performance, to create a harmonious sound image.
The components were put together in such a way that the amplifiers produce the maximum possible performance with the selected speakers.
The set includes everything you need for complete and safe cabling!
If you do not need individual components, or want to exchange them for others, write us briefly, we will then change the offer immediately according to your wishes.
The set includes the following components:
- 1x DD Audio D4.90 4-channel amplifier
- 1x Scanspeak Discovery 820013 front system
- 1x DD Audio LE-M08D 20cm subwoofer
- 1x Stinger SK4281 10mm² cable set incl. fuse (free of charge)
- 1x 15m 1,5mm² speaker cable (free of charge)
What you could optionally
use in addition:
-
RCA cable. Do you have an aftermarket radio or a factory radio? If you have an aftermarket radio, you need the right amount of RCA cables, which you can find under our accessories. You need 1 cable per channel. If you have a factory radio, connect the original speaker wires to the high inputs of the power amp, or use a separate Hi-Low converter.
-
Attenuation. With the increased music power, trim parts can suddenly start to vibrate. For this purpose you can cover them from the inside with Alubutyl, this is also recommended for the inside of the vehicle sheet metal, with which you can create an even clearer sound reproduction, without disturbing noises.
-
Additional battery. Depending on the existing vehicle battery, it is useful from about 600W total power of the amplifier, to install an additional battery. You can find this under our accessories -> batteries. For which amplifier power, the respective battery is useful, is noted in the title of the batteries.
-
Capacitor (PowerCap). A capacitor compensates for the voltage drops that can occur in the vehicle electrical system during strong bass hits. This is noticeable by an unclean bass reproduction, or slightly dimming lights in the interior. Here, a power cap or an additional battery provides a remedy.
-
Rear system. The speakers in the rear doors of your car do not have the same power as the front system. Generally it is sufficient to replace only the front system. However, if you want a homogeneous sound from all speakers, we will be happy to create an individual complete set for you.
Key Features DD Audio D4.90 4-channel amplifier:
- 4-channel amplifier in compact design
- 2-Ohm stable
- Power @ 4Ω: 4 x 90 W
- Power @ 2Ω: 4 x 120 W
- Power @ 4Ω: 2 x 240 W
- Signal to noise ratio 80dB
- Dimensions: 233 x 125 x 47 mm
Key Features Scanspeak Discovery 820013 Front System:
- 2-way Scanspeak Automotive Discovery Series Speaker Set.
- The set contains:
- 2 pcs. R1904/613001 tweeter (19 mm)
- 2 pcs. 16W/4434G00 bass-midrange driver (165 mm)
- 2 crossovers
- special cable
- grille
- one pair of gloves
- stickers and an extra logo
Key Features DD Audio LE-M08D 20cm Subwoofer:
- DD Redline Series Subwoofer
- 8" (20cm) sandwich paper cone
- D2 (2x2Ohm) impedance
- Patented ferrite magnet system
- Lossless linear suspension
- Foam surround
- Die cast aluminum basket
- Tuning frequency: 41 Hz
- Recommended amplifier power: 500 Watt RMS
- Dimensions: 438 x 266 x 241 mm
Key Features: Stinger SK4281 10mm² Cable Set:
- Cable set for a maximum amplifier power of 600 watts (RMS) / 60A.
- Cable cross section: 10 mm² made of 100% copper!
- Scope of delivery:
- 5,5m Hyper-Twist 10mm² OFC power cable (matt red)
- 0,9m Hyper-Twist 10mm² OFC ground cable (matt-black)
- 5,18m 0,82mm² remote power cable (matt-blue)
- 60A fuse
- Fuse holder SPD5101 AGU
- 10mm² crimp ring terminals, pre-installed
- 1.5mm² Piston Connector (blue)
- 10mm² Snap In Protective Fire Sleeve
- Mounting screws
- 10x cable ties 17,8cm
